Home › Guides › Spin in 3-Cushion Billiards

Spin in 3-Cushion Billiards

Where you strike the cue ball decides how it leaves the first cushion. Here is how side spin, follow and draw really work — and how to practise them.

▶ Practice free now

Why spin matters more in three-cushion

In pocket games you can often play a whole rack with a centre-ball hit. In three-cushion that is almost impossible. Every point needs the cue ball to touch at least three cushions before the second object ball, and the angle at which the ball leaves each cushion depends heavily on the spin it carries. Spin is not decoration in carom — it is the steering wheel.

There are two families of spin. Side spin (called english) rotates the ball around a vertical axis and mostly changes what happens at the cushions. Follow and draw rotate the ball around a horizontal axis and mostly change what happens after the cue ball hits an object ball.

Tip position: think in levels

Players describe the contact point as "levels" or "tips" of spin. A common teaching scale counts outward from the centre in equal steps: level 0 is the centre and each level moves the contact point a little further out. Around level 4 you are half a radius from the centre, which is close to the practical limit before the tip slips off the ball (a miscue). Chalking before every shot is what lets you use those outer levels safely.

Because the ball is a sphere, the high- and low-spin positions are not on a straight cross. As you add side spin to a follow or draw shot, the contact point slides along the curve of the ball from the top (or bottom) towards the equator. You cannot have maximum follow and maximum side spin at the same time — that combination is outside the miscue limit.

Rule of thumb: use the smallest amount of spin that does the job. Extra spin makes the outcome more sensitive to small errors in speed and aim.

Running and reverse english

Side spin is described relative to the direction the cue ball is travelling when it reaches the cushion.

  • Running english is spin on the same side as the ball's direction of travel along the rail. It "rolls with" the cushion, so the ball comes off at a wider, longer angle and keeps more of its speed.
  • Reverse english spins against the direction of travel. The cushion grips the spin, the rebound angle shortens, and the ball loses more speed.
  • No english on a slow, natural-rolling ball gives a rebound close to the mirror angle — the angle out roughly equals the angle in. Medium and hard shots shorten that angle a little because the ball digs into the rubber.

Most three-cushion patterns — the corner shots, the "around the table" and the long-angle systems — are designed around running english, because it keeps the ball travelling and makes the path more predictable over three or more rails.

English survives several cushions

Side spin does not disappear at the first cushion. Each contact converts part of it into sideways speed and the cloth slowly wears down the rest, but a well-struck ball often still carries useful english into the second and third rails. That is why the same tip position produces a longer path on a fast cloth than on a slow one, and why system numbers need small corrections from table to table.

Follow, draw and the "stun"

Follow (top spin) makes the cue ball keep rolling forward after it contacts an object ball. Draw (back spin) makes it come back. A stun shot — struck so the ball slides without spin at the moment of contact — sends the cue ball off at about 90° to the object ball's path on a cut shot.

In carom these matter because your first object ball sets up the whole path. A thin hit with follow bends the cue ball forward and keeps it running; a fuller hit with draw lets you send the cue ball back across the table to start a different pattern. Remember that the ball naturally picks up roll as it travels, so draw needs enough speed to survive the distance to the object ball.

Stroke length changes the result

A short, crisp "stop" stroke and a long, smooth follow-through can produce different spin at the same tip position. Many players keep the tip position constant and change the stroke to fine-tune the shot.

Masse: when the ball curves

With the cue held level, side spin alone does not make the cue ball curve on the cloth — the spin axis is vertical, so it has nothing to push against. Curve appears when you raise the cue butt. An elevated cue tilts the spin axis, the spinning ball grips the cloth sideways, and the path bends. That is a masse. Small elevations give a gentle swerve that helps you get around a blocking ball; steep elevations are specialist shots.

Three drills to build feel

  1. One-rail ladder. Place the cue ball at the middle of the table and shoot it into the long rail at the same angle five times: no english, then running levels 1 to 4. Mark where it lands on the opposite rail each time. You are building a personal table of "how much wider" each level plays.
  2. Reverse check. Repeat the ladder with reverse english. Notice how quickly the angle closes and how much speed the ball loses.
  3. Follow or draw off a ball. Set a half-ball cut on an object ball and hit it with stun, then follow, then draw. Watch the cue ball's departure angle change from about 90° to forward and back.

You can run all three drills in the free BADENNIS trainer: the spin picker uses the same level scale, and the aiming guide is driven by the same physics engine as the real shot, so you can compare the prediction with the result.